Obd-diag Port Devices Driver Download For Windows 10

Posted on  by



Obd-diag port devices driver download for windows 10 32-bit

Obd-diag Port Devices Driver Download For Windows 10

Obd-diag Port Devices Driver Download For Windows 10 64-bit

Obd-diag Port Devices Driver Download For Windows 10Obd-diag

Obd-diag Port Devices Driver Download For Windows 10 32-bit

When you plug the device into your USB, Windows will look for the associated driver, if it cannot find this driver then you will be prompted to insert the driver disc that came with your device. Common USB Device errors are ‘ usb port not working ‘, ‘device descriptor request failed error’ or ‘bugcodeusbdriver’ issues. Open Start Settings Devices Printers & scanners. Select the name of the printer, and then choose Remove device. To reinstall the printer, select Add a printer or scanner and then select the name of the printer you want to add. If Windows doesn’t automatically find a new driver after the printer is added, look for one on the device. For Windows XP/7/8.1/10 (32/64 bit) For ELM327 USB Scanners with the CH340 Serial to USB Chip. If the FTDI, Silicon Labs or Prolific USB drivers do not work for your scanner, it's most likely you need this driver Windows CH340 USB to Serial Driver: Link 1: For Windows XP/7/8.1/10 (32/64 bit) Mac OS CH340 USB to Serial Driver: Link 1: Supports.

Download Windows 10

  1. Plug ELM327 WIFI Scanner into vehicle's OBD2 port. (Port is usually found on the driver side dashboard under the steering wheel.)
  2. Turn ON ignition. (This is one step before engine is powered.)
  3. Inside Windows WIFI manager — connect to Wi-Fi signal with name similar to these examples: WIFI ELM327, WiFiOBD, OBDDevice, V-Link.
    NOTE: It can take up to 30 seconds to WIFI signal to show.
    Password to connect to WIFI: 12345678


  4. Once you've connected, right-click on the WIFI signal and click 'Status'. The following window will appear:

  5. Click on 'Properties'.

    Change the connection's TCP/IP setting by entering a static IP address.
    Set the IP as:
    192.168.0.11

    And the subnet mask as:
    255.255.255.0


    The new settings are complete. Close all windows and go to next step below...

  6. Launch your OBD Software. (We recommend TOAD software which is 100% compatible with WIFI.)
  7. Go to software Settings and configure it to look for WIFI. (It's usually set to USB or Bluetooth).
  8. Configure WIFI IP Address to 192.168.0.11 (or 192.168.0.10) and Port to 35000. (Or number that sellers/manufacturers page has stated. Check their website where you bought your WIFI ELM327.)
  9. Software should now successfully connect to your vehicle.